ISO 10897 Collets for tool holders with taper ratio 1:10 - Collets, holders, nuts - Second Edition
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ISO 10889-6 Tool holders with cylindrical shank - Part 6: Type E with cylindrical seat - Third Edition
- 25
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- 23
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- ISO 1940-1 CORR 1 Mechanical vibration — Balance quality requirements for rotors in a constant (rigid) state — Part 1: Specification and verification of balance tolerances TECHNICAL CORRIGENDUM 1 - Second Edition
- CEN EN 847-3 Tools for woodworking - Safety requirements - Part 3: Clamping devices
- ISO 10897 Collets for Tool Holders with Taper Ratio 1:10 - Collets, Holders, Nuts - First Edition
- Картотека зарубежных и международных стандартов
International Organization for Standardization
Collets for tool holders with taper ratio 1:10 - Collets, holders, nuts - Second Edition
N 10897
Annotation
This International Standard specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.
Form A applies where a clamping range of H10 is sufficient.
Form B can be used for any application without lateral cutting load.
Annex A specifies the values for AT3 tolerance and AT4 tolerance.
Автоматический перевод:
Оправы для держателей инструментов с коэффициентом сужения 1:10 - Оправ, держателей, орехов - Второй Выпуск
Этот Международный стандарт определяет размеры, материалы и производственные требования и обозначение оправ для инструментов с цилиндрическими ногами и их соответствующими держателями и орехами. Для нестандартизированных зажимных устройств, таких как зажимные устройства, определенные в рисунках, эти держатели могут быть согласованы между клиентом и поставщиком.
