ISO 10889-6 Tool holders with cylindrical shank - Part 6: Type E with cylindrical seat - Third Edition
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- 25
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- 23
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- ISO 1940-1 CORR 1 Mechanical vibration — Balance quality requirements for rotors in a constant (rigid) state — Part 1: Specification and verification of balance tolerances TECHNICAL CORRIGENDUM 1 - Second Edition
- CEN EN 847-3 Tools for woodworking - Safety requirements - Part 3: Clamping devices
- ISO 10897 Collets for Tool Holders with Taper Ratio 1:10 - Collets, Holders, Nuts - First Edition
- Картотека зарубежных и международных стандартов
International Organization for Standardization
Tool holders with cylindrical shank - Part 6: Type E with cylindrical seat - Third Edition
N 10889-6
Annotation
This part of ISO 10889 specifies dimensions, designations, and complementary technical delivery conditions for tool holders with cylindrical seat of types E1 to E4 with a mounting system cylindrical shank in accordance with ISO 10889-1.
ISO 10889 is applicable to tool holders with cylindrical shank for machine tools with non-rotating tools, preferably for turning machines.
For non-standardized tool holders, such as tool holders with a cylindrical seat as shown in Figures 1 to 4, it is advisable to apply the corresponding specifications of this part of ISO 10889.
Автоматический перевод:
Держатели инструментов с цилиндрическим стержнем - Часть 6: Тип E с цилиндрическим местом - Третий Выпуск
Эта часть ISO 10889 указывает размерности, обозначения и дополнительные технические условия поставки для держателей инструментов с цилиндрическим местом типов E1 к E4 с монтирующейся системой цилиндрический стержень в соответствии с ISO 10889-1.
ISO 10889 применим к держателям инструментов с цилиндрическим стержнем для устройств с невращающимися инструментами, предпочтительно для превращения машин.
