Deutsches Institut fur Normung e. V.

Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures (:2014)
 N ISO 815-2

Annotation

This part of ISO 815 specifies two methods for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low temperatures.

Method 1 derives from the methodology used in ISO 815-1. Method 2 uses a specified testing device, allowing to measure and record the test piece thickness during recovery. Due to the load applied during recovery in method 2, no correlation can be established between the results given by both methods.

NOTE When rubber is held under compression, physical or chemical changes can occur that prevent the rubber returning to its original dimensions after release of the deforming force. The result is a set, where the magnitude of which depends on the time and temperature of compression as well as on the time, temperature, and conditions of recovery. At low temperatures, changes resulting from the effects of glass hardening or crystallization become predominant and, since these effects are reversed by raising the temperature, it is necessary for all measurements to be undertaken at the test temperature.

Автоматический перевод:

Резина, вулканизировавшая или термопласт - Определение остаточной деформации при сжатии - Часть 2: При низких температурах (815-2:2014 ISO)

Эта часть ISO 815 указывает два метода для определения характеристик набора сжатия вулканизировавших и термопластических резиновых изделий при низких температурах.