ASTM International

Standard Test Method for Oil Separation from Lubricating Grease (Conical Sieve Method)
 N D6184

Annotation

This test method covers the determination of the tendency of lubricating grease to separate oil at an elevated temperature. This test method shall be conducted at 100 °C for 30 h unless other conditions are required by the grease specification.

This test method is suitable for use with most all greases, but the test precision was established using greases having a worked penetration (Test Methods D217) greater than 220 (NLGI No. 3 grade) and less than 340 (NLGI No. 1 grade).

The values stated in SI units are to be regarded as standard. The term 60 mesh was originally described in the now withdrawn E437 standard. It is used to describe the wire mesh because there is no exact metric equivalent.

This standard does not purport to address all the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартный метод тестирования для нефтяного разделения от смазки смазки (конический метод решета)

Этот метод тестирования покрывает определение тенденции смазки смазки для разделения нефти при повышенной температуре. Этот метод тестирования должен проводиться в 100 °C в течение 30 ч, если другие условия не будут требоваться спецификацией смазки.