ASTM International

Standard Practice for Characterizing Acoustic Emission Instrumentation
 N E750

Annotation

This practice is recommended for use in testing and measuring operating characteristics of acoustic emission electronic components or units. (See Appendix X1 for a description of components and units.) It is not intended that this practice be used for routine checks of acoustic emission instrumentation, but rather for periodic evaluation or in the event of a malfunction. The sensor is not addressed in this document other than suggesting methods for standardizing system gains (equalizing them channel to channel) when sensors are present.

Where the manufacturer provides testing and measuring details in an operating and maintenance manual, the manufacturer’s methods should be used in conjunction with the methods described in this practice.

The methods (techniques) used for testing and measuring the components or units of acoustic emission instrumentation, and the results of such testing and measuring should be documented. Documentation should consist of photographs, screenshots, charts or graphs, calculations, and tabulations where applicable.

AE systems that use computers to control the collection, storage, display, and data analysis, might include waveform collection as well as a wide selection of measurement parameters (features) relating to the AE signal. The manufacturer provides a specification for each system that specifies the operating range and conditions for the system. All calibration and acceptance testing of computer-based AE systems must use the manufacturer’s specification as a guide. This practice does not cover testing of the computer or computer peripherals.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.