DIN EN 302-6 Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the minimum pressing time under referenced conditions
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN 766 Calibrated and tested grade 3 round steel link chains
- 53
- DIN 766 Calibrated and tested grade 3 round steel link chains
- 53.020
- DIN 766 Calibrated and tested grade 3 round steel link chains
- 53.020.30
- DIN 766 Calibrated and tested grade 3 round steel link chains
- DIN 8176 Conveyor chains; bush conveyor chains for haulage systems
- DIN 8176 Conveyor chains; bush conveyor chains for haulage systems
- VDI 2320 Continuous conveyors survey - Drag chain conveyors
- ISO 1834 Short Link Chain for Lifting Purposes - General Conditions of Acceptance - Second Edition
- DIN 79000 Permanently installed outdoor fitness equipment - Safety requirements and test methods
- DIN EN 350-2 Durability of wood and wood based products - Natural durability of solid wood - Part 2: Guide to the natural durability and treatability of selected wood species of importance in Europe
- DIN EN 16351 Timber structures - Cross laminated timber - Requirements
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Adhesives for load-bearing timber structures - Test methods - Part 6: Determination of the minimum pressing time under referenced conditions
N EN 302-6
Annotation
This European Standard specifies a method of determining the minimum pressing time for two glue line thicknesses, close contact glue line and 0,3 mm thick glue line (for gap filling adhesive 1,0 mm), at three temperatures. It is applicable to adhesives used in load- bearing timber structures.
This European Standard is only intended for obtaining a reliable base of comparison of pressing time between adhesives. The method gives results that cannot be applied to the safe manufacture of timber structures without modifications for the influences of timber density/absorbency, moisture content, factory temperature and relative air humidity.
Автоматический перевод:
Пластыри для имеющих груз структур древесины - Методов испытаний - Часть 6: Определение минимального неотложного времени при условиях, на которые ссылаются,
Этот европейский стандарт определяет метод определения минимального времени стремления для двух толщин клеевого шва, клеевого шва тесного контакта и клеевого шва 0,3 мм толщиной (для клея заполняющий зазоры 1,0 мм), при трех температурах. Это применимо к пластырям, используемым в грузе - отношение структур древесины.
