ASTM D6524/D6524M Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13.030
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13.030.40
- ASTM D6009 Standard Guide for Sampling Waste Piles
- ASTM D5680 Standard Practice for Sampling Unconsolidated Solids in Drums or Similar Containers
- ASTM D6232 Standard Guide for Selection of Sampling Equipment for Waste and Contaminated Media Data Collection Activities
- ASTM D6051 Standard Guide for Composite Sampling and Field Subsampling for Environmental Waste Management Activities
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Measuring the Resiliency of Turf Reinforcement Mats (TRMs)
N D6524/D6524M
Annotation
This test method covers the resiliency or recovery of turf reinforcement mats (TRMs) after they have been subjected to three cycles of loading at 689 kPa [100 psi] for 1 min/per cycle.
This test method does not provide resiliency values for TRMs under variable normal compressive stresses. This test method determines nominal resiliency.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартный метод испытаний для измерения упругости циновок укрепления торфа (TRMs)
Этот метод тестирования покрывает упругость или восстановление циновок укрепления торфа (TRMs) после того, как они были подвергнуты трем циклам загрузки на уровне 689 кПа [100 фунтов на квадратный дюйм] для 1 минимального/на цикла.
