ASTM International

Standard Test Method for Analysis of Low-Alloy Steels by Wavelength Dispersive X-Ray Fluorescence Spectrometry
 N E1085

Annotation

This test method covers the wavelength dispersive X-ray fluorescence analysis of low-alloy steels for the following elements:

NOTE 1—Unless exceptions are noted, mass fraction ranges can be extended and additional elements can be included by the use of suitable reference materials and measurement conditions. Deviations from the published scope must be validated by experimental means. See Guide E2857 for information on validation options.

The values stated in the International System of Units (SI) are to be regarded as standard. The values given in parentheses are mathematical conversions to other units that are provided for information only, because they may used in older software and laboratory procedures.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific precautionary statements are given in Section 10.

Автоматический перевод:

Метод стандартной пробы для анализа низколегированной стали длиной волны дисперсионная спектрометрия флуоресценции рентгеновских лучей

Этот метод тестирования покрывает длину волны дисперсионный люминесцентный анализ рентгена низколегированной стали для следующих элементов: