JSA JIS G 3115 Steel plates for pressure vessels for intermediate temperature service
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040.60
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.100
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- ISO 6162-1 Hydraulic fluid power - Flange connections with split or one-piece flange clamps and metric or inch screws - Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 - Second Edition
- JSA JIS B 8363 End fittings and adapters for hydraulic hose assemblies
- JSA JIS B 2401-1 O-rings - Part 1: O-rings
- JSA JIS G 4305 AMD 1 Cold-rolled stainless steel plate, sheet and strip (Amendment 1)
- JSA JIS Z 2306 Radiographic image quality indicators for non-destructive testing
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Steel plates for pressure vessels for intermediate temperature service
N JIS G 3115
Annotation
This Standard specifies hot rolled steel plates (hereafter referred to as "steel plates") with improved weldability, to be used for pressure vessels, equipment for high pressure service (excluding those to be used for high and low temperature services).
NOTE: The International Standards corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 9328-1: 2011 Steel flat products for pressure purposes-Technical delivery conditions-Part 1: General requirements
ISO 9328-3: 2011 Steel flat products for pressure purposes-Technical delivery conditions-Part 3: Weldable fine grain steels, normalized
ISO 9328-5: 2011 Steel flat products for pressure purposes-Technical delivery conditions-Part 5: Weldable fine grain steels, thermomechanically rolled
ISO 9328-6: 2011 Steel flat products for pressure purposes-Technical delivery conditions-Part 6: Weldable fine grain steels, quenched and tempered (overall evaluation: MOD)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standards and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Стальные плиты для сосудов давления для промежуточного температурного обслуживания
