DIN EN ISO 4759-3 Tolerances for fasteners - Part 3: Washers for bolts, screws and nuts - Product grades A, C and F (ISO 4759-3:2016)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN LN 9025 Aerospace - Washers
- 49
- DINGCD23
- DIN EN 14399-6 High-strength structural bolting assemblies for preloading - Part 6: Plain chamfered washers; German version EN 14399-6:2015
- DIN EN 14399-10 High-strength structural bolting assemblies for preloading - Part 10: System HRC - Bolt and nut assemblies with calibrated preload
- DIN EN 14399-10 High-strength structural bolting assemblies for preloading - Part 10: System HRC - Bolt and nut assemblies with calibrated preload
- DIN EN 14399-5 High-strength structural bolting assemblies for preloading - Part 5: Plain washers
- DIN EN 14399-1 High-strength structural bolting assemblies for preloading - Part 1: General requirements
- DIN EN ISO 4759-3 Tolerances for fasteners - Part 3: Plain washers for bolts, screws and nuts - Product grades A and C (ISO 4759-3:2000)
- ISO 1101 Geometrical product specifications (GPS) - Geometrical tolerancing - Tolerances of form, orientation, location and run-out - Fourth Edition
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Tolerances for fasteners - Part 3: Washers for bolts, screws and nuts - Product grades A, C and F (ISO 4759-3:2016)
N EN ISO 4759-3
Annotation
This part of ISO 4759 specifies tolerances for flat washers of product grades A, C and F with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts.
This part of ISO 4759 may be applied to non-flat washers however it does not include all the tolerances related to these washers.
It applies to non-captive and captive washers, and to standard and non-standard washers.
It does not apply to dynamic disc springs.
Washers of product grades F and A are intended to be used with bolts, screws, studs and nuts of product grades A and B; washers of product grade C are intended to be used with bolts, screws, studs and nuts of product grade C.
NOTE The product grade refers to a specific tolerance range related to dimensional and geometrical characteristics (product grade F for fine tolerances, product grade A for precise tolerances, product grade C for large tolerances).
Annex A presents tolerances taken from ISO 286-1 and ISO 286-2.
Автоматический перевод:
Допуски для застежек - Часть 3: Шайбы для болтов, винтов и гаек - продукт градуируют A, C и F (4759-3:2016 ISO)
Эта часть ISO 4759 определяет, что допуски для плоских шайб продукта градуируют A, C и F с номинальными диаметрами от 1 мм до 150 мм включительно, разработанный, чтобы использоваться в болтовых соединениях в сочетании с болтами, винтами, жеребцами и гайками.
