ASTM International

Standard Specification for Rolled Zinc
 N B69

Annotation

This specification covers two types of commercial rolled zinc as described in 1.2. It should be understood that the specification is general. Any closer limitations on permissible variations shall be a matter of agreement between the supplier (manufacturer) and the purchaser.

Rolled zinc is furnished in two types as follows:

Type I—Coils or sheets cut from strip (ribbon) rolled zinc and

Type II—Coils or sheets cut from strip (ribbon) rolled zinc

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартная спецификация для прокрученного цинка

Эта спецификация покрывает два типа коммерческого прокрученного цинка, как описано в 1.2. Нужно подразумевать, что спецификация является общей. Любые более близкие ограничения на допустимые изменения должны быть вопросом соглашения между поставщиком (производитель) и покупателем.