ASTM International

Standard Specification for General Requirements for Rolled Structural Steel Bars, Plates, Shapes, and Sheet Piling
 N A6/A6M REV A

Annotation

This general requirements specification2 covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to rolled structural steel bars, plates, shapes, and sheet piling covered

Annex A1 lists permitted variations in dimensions and mass (Note 1) in SI units. The values listed are not exact conversions of the values in Tables 1 to 31 inclusive but are, instead, rounded or rationalized values. Conformance to Annex A1 is mandatory when the “M” specification designation is used

NOTE 1—The term “weight” is used when inch-pound units are the standard; however, under SI, the preferred term is “mass.”

Annex A2 lists the dimensions of some shape profiles

Appendix X1 provides information on coil as a source of structural products

Appendix X2 provides information on the variability of tensile properties in plates and structural shapes

Appendix X3 provides information on weldability

Appendix X4 provides information on cold bending of plates, including suggested minimum inside radii for cold bending

This general requirements specification also covers a group of supplementary requirements that are applicable to several of the above product specifications as indicated therein. Such requirements are provided for use where additional testing or additional restrictions are required by the purchaser, and apply only where specified individually in the purchase order

In case of any conflict in requirements, the requirements of the applicable product specification prevail over those of this general requirements specification