ASTM B758 Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloys (UNS N06110) Welded Tube
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASME B31.5 Refrigeration Piping and Heat Transfer Components
- ASTM B43 Standard Specification for Seamless Red Brass Pipe, Standard Sizes
- ASTM B43 Standard Specification for Seamless Red Brass Pipe, Standard Sizes
- ASTM B687 Standard Specification for Brass, Copper, and Chromium-Plated Pipe Nipples
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Nickel-Chromium-Molybdenum-Tungsten Alloys (UNS N06110) Welded Tube
N B758
Annotation
This specification covers welded UNS N061102 tube in the annealed condition (temper) for general corrosion applications.
This specification covers outside diameter and nominal wall tube.
The tube sizes covered by this specification are 1?8 to 5 in. (3.2 to 127 mm) in outside diameter and 0.015 to 0.148 in. (0.4 to 3.8 mm), inclusive, in wall thickness.
The values stated in inch-pound units are to be regarded as the standard. The SI units in parentheses are provided for information only.
The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.
2 New designation established in accordance with Practice E527 and SAE J1086, Recommended Practice for Numbering Metals and Alloys (UNS).
Автоматический перевод:
Стандартная спецификация для вольфрамовых сплавов молибдена хрома никеля (UNS N06110) сварная труба
Эта спецификация касается сварной трубы UNS N061102 в отожженном условии (характер) для общих применений коррозии.
