European Committee for Standardization

Heat meters - Part 3: Data exchange and interfaces
 N EN 1434-3

Annotation

This European Standard specifies the general requirements and applies to heat meters. Heat meters are instruments intended for measuring the energy which in a heat-exchange circuit is absorbed (cooling) or given up (heating) by a liquid called the heat-conveying liquid. The meter indicates heat in legal units.

Part 3 specifies the data exchange between a meter and a readout device (POINT / POINT communication). For these applications using the optical readout head, the EN 62056-21 protocol is recommended.

For direct or remote local readout of a single or a few meters via a battery driven readout device, the physical layer of EN 13757-6 (local bus) is recommended. For bigger networks with up to 250 meters, a master unit with AC mains supply according to EN 13757- 2 is necessary to control the M-Bus.

For these applications the physical and link layer of EN 13757-2 and the application layer of EN 13757-3 is required.

For wireless meter communications, EN 13757-4 describes several alternatives of walk/drive-by readout via a mobile station or by using stationary receivers or a network. Both unidirectionally and bidirectionally transmitting meters are supported by this standard.

Автоматический перевод:

Тепломеры - Часть 3: Обмен данными и интерфейсы

Этот европейский стандарт определяет общие требования и относится к тепломерам. Тепломеры являются инструментами, предназначенными для измерения энергии, в схеме теплообмена абсорбированной (охладившись) или брошенный (нагревание) жидкостью, названной передающей тепло жидкостью. Метр указывает на тепло в юридических единицах.