JSA JIS Z 3607 Friction welding of metallic materials
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- JSA JIS Z 3607 Friction welding of metallic materials
- 25
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- ISO 6162-1 Hydraulic fluid power - Flange connections with split or one-piece flange clamps and metric or inch screws - Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 - Second Edition
- ISO 6162-1 Hydraulic fluid power - Flange connections with split or one-piece flange clamps and metric or inch screws - Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 - Second Edition
- JSA JIS B 8363 End fittings and adapters for hydraulic hose assemblies
- JSA JIS B 2401-1 O-rings - Part 1: O-rings
- JSA JIS G 4305 AMD 1 Cold-rolled stainless steel plate, sheet and strip (Amendment 1)
- JSA JIS Z 3175 Methods of test and classification of quality evaluations for friction welded joints on dissimilar metallic materials
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Friction welding of metallic materials
N JIS Z 3607
Annotation
This Standard specifies requirements for the friction welding of components manufactured from metals.
It specifies requirements particular to rotational friction welding related to welding knowledge, quality requirements, welding procedure specification, welding procedure approval and welding personnel.
NOTE: The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
ISO 15620: 2000 Welding-Friction welding of metallic materials (MOD)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Сварка трением металлических материалов
Этот Стандарт указывает требования для сварки трения компонентов, произведенных от металлов.
Это указывает требования, конкретные к вращательной сварке трения, связанной со сварочным знанием, требованиями к качеству, сварочной спецификацией процедуры, сварочным одобрением процедуры и сварочным персоналом.
