International Organization for Standardization

Welding - Calibration, verification and validation of equipment used for welding, including ancillary activities - Second Edition
 N 17662

Annotation

This International Standard specifies requirements for calibration, verification and validation of equipment used for

— control of process variables during fabrication, and

— control of the properties of equipment used for welding or welding allied processes

where the resulting output cannot be readily or economically documented by subsequent monitoring, inspection and testing. This involves process variables influencing the fitness-for-purpose and in particular the safety of the fabricated product.

NOTE 1 This International Standard is based on the lists of process variables stated in International Standards for specification of welding procedures, in particular, but not exclusively in the ISO 15609- series. Future revisions of these International Standards can result in addition or deletion of parameters considered necessary to specify.

Some guidance is, in addition, given in Annex B as regards requirements for calibration; verification and validation as part of acceptance testing of equipment used for welding or allied processes.

Requirements to calibrate, verify and validate as part of inspection, testing, non-destructive testing or measuring of final welded products performed in order to verify confirm product compliance are outside the scope of the present International Standard.

The subject of this International Standard is limited to calibration, verification and validation of equipment after installation, as part of the workshops’ and site operations for maintenance and/or operation.