ASTM International

Standard Test Method for Determining In Situ Modulus of Deformation of Rock Mass Using Flexible Plate Loading Method
 N D4395

Annotation

This test method covers the preparation, equipment, test procedure, and data reduction for determining in situ modulus of deformation of a rock mass using the flexible plate loading method.

This test method is designed to be conducted in an adit or small underground chamber; however, with suitable modifications it could be conducted at the surface.

This test method is usually conducted parallel or perpendicular to the anticipated axis of thrust, as dictated by the design load.

Time-dependent tests not covered by this standard can be performed but are to be reported in another standard.

All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.

The method used to specifiy how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

The references appended to this standard contain further information on this test method.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precaution statements, see Section 8.