ASTM International

Standard Specification for Carbon Steel and Low-Alloy Steel Pressure-Vessel-Component Forgings with Mandatory Toughness Requirements
 N A765/A765M

Annotation

This specification2 covers heat-treated carbon steel and alloy steel forgings with mandatory toughness requirements. These forgings are intended for pressure vessels, feedwater heaters, and similar uses

These forgings include tube sheets, covers, channel barrels, integral forged channels, rings, nozzles, flanges, and similar parts

All grades are considered weldable under proper conditions

The maximum thickness of forgings produced to this specification is limited only by the capacity of the selected grade to respond to any heat treatment specified and to meet the specified mechanical tests, including impact tests at the specified temperature

Material supplied to this specification shall conform to the requirements of Specification A788/A788M, which outlines additional ordering information, manufacturing requirements, testing and retesting methods and procedures, marking, certification, product analysis variations, and additional supplementary requirements

If the requirements of this specification are in conflict with the requirements of Specification A788/A788M, the requirements of this specification shall prevail

The values stated in either inch-pound units or SI [metric] units are to be regarded separately as the standard; within the text and tables, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification

Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inchpound units