ASTM International

Standard Test Method for Determination of Total Organic Halides, Total Non-Methane Hydrocarbons, and Formaldehyde in Hydrogen Fuel by Gas Chromatography/Mass Spectrometry
 N D7892

Annotation

The gas chromatography/mass spectrometry (GC/MS) procedure described in this method is used to determine concentrations of total organic halides and total non-methane hydrocarbons (TNMHC) by measurement of individual target halocarbons (Table 1) and hydrocarbons (including formaldehyde, Table 1 and Table 2), respectively. Measurement of these substances is required for application of SAE J2719 to hydrogen fuel quality where this fuel is intended for use in fuel cell vehicles. SAE 2719 states hydrogen fuel is expected to contain less than 0.05 mole/mole total halogenates (including organic halides), 2 mole/mole total nonmethane hydrocarbons (C1 Basis, 3.2.16) and 0.01 mole/mole formaldehyde.

Based upon the GC/MS/full scan analysis of a 400 mL hydrogen sample, the reporting limit (RL) is 0.001 mole/mole for each target compound listed in Table 1 and Table 2, with the exception of 0.002 mole/mole for ethane and 0.002 mole/ mole for ethene.

Mention of trade names in this standard does not constitute endorsement or recommendation for use. Other manufacturers' equipment or equipment models can be used.

The values stated in SI units are to be regarded as standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.