ASTM B121/B121M Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040.15
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- ASTM B248 Standard Specification for General Requirements for Wrought Copper and Copper- Alloy Plate, Sheet, Strip, and Rolled Bar
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Leaded Brass Plate, Sheet, Strip, and Rolled Bar
N B121/B121M
Annotation
This specification establishes the requirements for leaded brass plate, sheet, strip, and rolled bar.
Units—Values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
Стандартная спецификация для пластины свинцовой латуни, листа, полосы и катившего бруска
Эта спецификация устанавливает требования для leaded медной таблички, листа, полосы и прокрученной панели.
Модули — Значения, утвержденные или в модулях дюйма-фунта или в единицах СИ, должны рассматриваться отдельно как стандарт. В рамках текста единицы СИ показывают в скобках. Значения, утвержденные в каждой системе, не могут быть точными эквивалентами; поэтому, каждая система должна использоваться независимо от другого. Объединение значений от этих двух систем может привести к несоответствию со стандартом.
