ASTM F1123 Standard Specification for Non-Metallic Expansion Joints
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- 23
- ASTM F1412 Standard Specification for Polyolefin Pipe and Fittings for Corrosive Waste Drainage Systems
- 23.040
- ASME B31E Standard for the Seismic Design and Retrofit of Above-Ground Piping Systems
- ASME B16.21 Nonmetallic Flat Gaskets for Pipe Flanges
- ASTM F363 Standard Test Method for Corrosion Testing of Gaskets
- ASTM F112 Standard Test Method for Sealability of Enveloped Gaskets
- ASTM F336 Standard Practice for Design and Construction of Nonmetallic Enveloped Gaskets for Corrosive Service
- ASME B16.24 Cast Copper Alloy Pipe Flanges and Flanged Fittings Classes 150, 300, 600, 900, 1500, and 2500
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Non-Metallic Expansion Joints
N F1123
Annotation
This specification provides the minimum requirements for construction, materials, performance, and dimensional requirements of arch-type non-metallic expansion joints.
The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
The following safety hazards caveat pertains only to the test method described in this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартная спецификация для неметаллических соединений расширения
Эта спецификация обеспечивает минимальные требования для строительства, материалов, производительности и размерных требований типовых дугой неметаллических соединений расширения.
Величины, указанные в единицах фунто-дюйма, должны рассматриваться как стандарт. Величины, данные в круглых скобках, только для информации.
