ASTM International

Standard Test Method for Sequential Batch Extraction of Waste with Water
 N D4793

Annotation

This test method is a procedure for the sequential leaching of a waste containing at least five % solids to generate solutions to be used to determine the constituents leached under the specified testing conditions.

This test method calls for the shaking of a known weight of waste with water of a specified purity and the separation of the aqueous phase for analysis. The procedure is conducted ten times in sequence on the same sample of waste and generates ten aqueous solutions.

This test method is intended to describe the procedure for performing sequential batch extractions only. It does not describe all types of sampling and analytical requirements that may be associated with its application.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Автоматический перевод:

Метод стандартной пробы для последовательной пакетной добычи отходов с водой

Этот метод тестирования является процедурой для последовательного выщелачивания отходов, содержащих твердые частицы на по крайней мере пять % для генерации решений, которые будут использоваться для определения составляющих, выщелоченных при указанных условиях тестирования.