ASTM B115 Standard Specification for Electrolytic Copper Cathode
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040.15
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- ASTM B972 Standard Specification for Nickel-Coated Braid and Ribbon Flat Copper Wire Intended for use in Electronic Application
- ASTM B49 REV A Standard Specification for Copper Rod for Electrical Purposes
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Electrolytic Copper Cathode
N B115
Annotation
This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon.
Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
NOTE 1—Cathode produced to this specification corresponds to the designation "Cath" as defined in Classification B224 and may be used to produce all other coppers listed in Classification B224 that are normally produced from "Cath" copper.
NOTE 2—Grade 1 cathode conforms to the chemical compositional requirements of Copper UNS No. C11040, except for oxygen, and is suitable for the manufacture of wire rod as designated in Specification B49.
The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
* A Summary of Changes section appears at the end of this standard.
Автоматический перевод:
Стандартная спецификация для катода электролитной меди
Эта спецификация устанавливает требования для катода электролитной меди; очищенный электролитическим способом и электровыигранный.
