ASTM B49 REV A Standard Specification for Copper Rod for Electrical Purposes
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040
- ASTM B983 REV A Standard Specification for Precipitation Hardened or Cold Worked, Seamless Nickel Alloy Pipe and Tube
- 23.040.15
- ASTM E1268 Standard Practice for Assessing the Degree of Banding or Orientation of Microstructures
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM E3 Standard Guide for Preparation of Metallographic Specimens
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B961 Standard Specification for Silver Coated Copper and Copper Alloy Stranded Conductors for Electronic Space Application
- ASTM B624 Standard Specification for High-Strength, High-Conductivity Copper-Alloy Wire for Electronic Application
- ASTM E8/E8M REV A Standard Test Methods for Tension Testing of Metallic Materials
- ASTM B706 Standard Specification for Seamless Copper Alloy (UNS No. C69100) Pipe and Tube
- ASTM B193 Standard Test Method for Resistivity of Electrical Conductor Materials
- ASTM B972 Standard Specification for Nickel-Coated Braid and Ribbon Flat Copper Wire Intended for use in Electronic Application
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Copper Rod for Electrical Purposes
N B49 REV A
Annotation
This specification covers the requirements for rod drawing stock in diameters from 1?4 to 13?8 in. (6.4 to 35 mm) produced from electrolytic tough-pitch or oxygen-free coppers and are suitable for further fabrication into electrical conductors.
The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
The following safety hazards caveat pertains only to Section 13.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
*A Summary of Changes section appears at the end of this standard.
Автоматический перевод:
Стандартная спецификация для медного стержня в электрических целях
Эта спецификация удовлетворяет требования для акций рисования стержня в диаметрах от 1 4 до 13 8 в. (6.4 к 35 мм), произведенный из электролитической жесткой подачи или бескислородных медей и подходят для дальнейшего производства в электрические проводники.
