ASTM D6661 Standard Practice for Field Collection of Organic Compounds from Surfaces Using Wipe Sampling
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13.030
- ASTM D7204 Standard Practice for Sampling Waste Streams on Conveyors
- 13.030.40
- ASTM D6282/D6282M Standard Guide for Direct Push Soil Sampling for Environmental Site Characterizations
- ASTM D1452 Standard Practice for Soil Exploration and Sampling by Auger Borings
- ASTM D1452 Standard Practice for Soil Exploration and Sampling by Auger Borings
- ASTM D6063 Standard Guide for Sampling of Drums and Similar Containers by Field Personnel
- ASTM D5680 Standard Practice for Sampling Unconsolidated Solids in Drums or Similar Containers
- ASTM D6051 Standard Guide for Composite Sampling and Field Subsampling for Environmental Waste Management Activities
- ASTM D6232 Standard Guide for Selection of Sampling Equipment for Waste and Contaminated Media Data Collection Activities
- ASTM D6009 Standard Guide for Sampling Waste Piles
- ASTM D5681 Standard Terminology for Waste and Waste Management
- Картотека зарубежных и международных стандартов
ASTM International
Standard Practice for Field Collection of Organic Compounds from Surfaces Using Wipe Sampling
N D6661
Annotation
This practice addresses sampling of organic compounds (i.e., PCBs, dioxins, many pesticides and similar compounds) from smooth nonporous surfaces using a solvent-wetted wipe sampling method. Samples are collected in a manner that permits the solvent extraction of the organic compound(s) of interest from the wipes and subsequent determination using a laboratory analysis technique such as gas chromatography with a suitable detector. This practice is, however, unsuitable for the collection of volatile organic compounds.
This practice should only be used to collect samples for the determination of organic compound(s) on a loading basis (e.g., mass per unit area). It cannot be used to collect samples for the determination of organic compounds on a concentration basis (e.g., mass per unit mass).
This wipe sampling practice is not recommended for collecting samples of organic compounds from rough or porous surfaces such as upholstery, carpeting, brick, rough concrete, ceiling tiles, and bare wood. It is also not intended for the collection of dust samples (see Practice E1278) or sampling to estimating human exposure to contaminated surfaces.
To ensure valid conclusions are reached, a sufficient number of samples must be obtained as directed by a sampling design (the number and location of samples including quality control samples) and a quality assurance/quality control plan. This practice does not address the sampling designs used to achieve the data quality objectives (see Practice D5792).
The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
