ASTM International

Standard Practice for Collection of a Gross Sample of Coal
 N D2234/D2234M

Annotation

This practice covers procedures for the collection of a sample under various conditions of sampling. The sample is to be crushed and further prepared for analysis in accordance with Practice D2013/D2013M. However, the procedures for dividing large samples before any crushing are given in this practice. For the sampling of coal using mechanical sampling systems see D7430 Practice for the Mechanical Sampling of Coal.

This practice describes general and special purpose sampling procedures for coals (1) by size and condition of preparation (for example, mechanically cleaned coal or raw coal) and (2) by sampling characteristics.

The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Автоматический перевод:

Утвержденный технологический процесс для коллекции грубого образца угля

Эта практика покрывает процедуры для набора образца при различных условиях выборки. Образец должен быть сокрушен и далее подготовлен к анализу в соответствии с Практикой D2013/D2013M. Однако процедуры для деления больших выборок перед любым сокрушением даны в этой практике. Для выборки угля с помощью систем отбора механического устройства см. Практику D7430 для Механической Выборки Угля.