ASTM International

Standard Specification for Fiberglass (Glass-Fiber-Reinforced Thermosetting-Resin) Pipe and Pipe Fittings, Adhesive Bonded Joint Type, for Aviation Jet Turbine Fuel Lines
 N D5677

Annotation

This specification covers a reinforced plastic pipe and fittings system made from epoxy resin and glass-fiber reinforcement, together with adhesive for joint assembly, intended for service up to 150°F (65.6°C) and 150-psig (1034-kPa) operating pressure and surges up to 275 psig (1896 kPa) in aviation jet turbine fuel lines installed below ground.

The dimensionless designator NPS has been substituted in this specification for such traditional terms as nominal diameter, size, and nominal size.

The values stated in inch-pound units are to be regarded as standard. The values in parentheses are for information only.

The following safety hazards caveat pertains only to the test method portion, Section 9, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—There is no known ISO equivalent to this standard.

Автоматический перевод:

Стандартная спецификация для стекловолокна (укрепленная стекловолокном термореактивная смола) монтажи труб и монтажи труб, адгезивный тип междурельсового стыкового соединения, для линий турбинного топлива реактивного самолета авиации