ASTM International

Standard Specification for Dimensions and Tolerances for Plastic Bottles
 N D2911/D2911M

Annotation

This specification covers the thread configuration and dimensions for finishes for plastic bottles with screw-type closures, having a maximum capacity of 18.9 L (5 gal) and a maximum bottle dimension of 305 mm (12 in.). Included are tolerances for bottle capacity and body dimensions.

Units—The values stated in either SI units or inchpound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

The following precautionary caveat pertains only to the test methods portion, Section 8 of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—There is no known ISO equivalent to this standard.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартная спецификация для измерений и допуски для пластмассовых бутылок

Эта спецификация покрывает конфигурацию потока и размерности для концов для пластмассовых бутылок с закрытиями типа винта, имея максимальную производительность 18.9 L (5 галов) и максимальную размерность бутылки 305 мм (12 дюймов.). Включенный допуски для емкости бутылки и размерностей организации.