ASTM International

Standard Test Method for Measurement of Cut Resistance to Chainsaw in Lower Body (Legs) Protective Clothing
 N F1414

Annotation

This test method measures cut resistance of garments and devices worn to protect the lower body (legs) when operating a chainsaw.

This test method may be used to test for compliance to minimum performance requirements in established safety standards.

By agreement between the purchaser and the supplier, or as required by established safety standards, it will be decided if this test method will be used to determine one or both of the following: (1) chain speed 50 (CS50), and (2) success/failure (jamming/chain stop or no cut in less than 1.5 s) at specified chain speed.

This test method may be used to determine levels of protection for areas of coverage as stipulated in established safety standards.

The values stated in SI units are to be regarded as standard.

NOTE 1—The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Автоматический перевод:

Стандартный метод тестирования для измерения сопротивления сокращения цепной пиле в более низком теле (участки) защитная одежда