International Organization for Standardization

Rubber, vulcanized or thermoplastic - Determination of compression set - Part 2: At low temperatures - Second Edition
 N 815-2

Annotation

This part of ISO 815-2:2008 specifies two methods for the determination of the compression set characteristics of vulcanized and thermoplastic rubbers at low temperatures.

Method 1 derives from the methodology used in ISO 815-1. Method 2 uses a specified testing device, allowing to measure and record the test piece thickness during recovery. Due to the load applied during recovery in method 2, no correlation can be established between the results given by both methods.

NOTE When rubber is held under compression, physical or chemical changes can occur that prevent the rubber returning to its original dimensions after release of the deforming force. The result is a set, where the magnitude of which depends on the time and temperature of compression as well as on the time, temperature and conditions of recovery. At low temperatures, changes resulting from the effects of glass hardening or crystallization become predominant and, since these effects are reversed by raising the temperature, it is necessary for all measurements to be undertaken at the test temperature.

Автоматический перевод:

Резина, вулканизировавшая или термопласт - Определение пластичной деформации - Часть 2: При низких температурах - Второй Выпуск

Эта часть 815-2:2008 ISO определяет два метода для определения особенностей пластичной деформации вулканизировавших и термопластичных каучуков при низких температурах.