ASTM D4141/D4141M Standard Practice for Conducting Black Box and Solar Concentrating Exposures of Coatings
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM G178 Standard Practice for Determining the Activation Spectrum of a Material (Wavelength Sensitivity to an Exposure Source) Using the Sharp Cut-On Filter or Spectrographic Technique
- 71
- ASTM G178 Standard Practice for Determining the Activation Spectrum of a Material (Wavelength Sensitivity to an Exposure Source) Using the Sharp Cut-On Filter or Spectrographic Technique
- 71.040
- ASTM D4940 Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blasting Abrasives
- ASTM F941 Standard Practice for Inspection of Marine Surface Preparation and Coating Application
- 47
- ASTM F718 Standard Specification for Shipbuilders and Marine Paints and Coatings Product/ Procedure Data Sheet
- ASTM D523 Standard Test Method for Specular Gloss
- ASTM D6763 Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents
- Картотека зарубежных и международных стандартов
ASTM International
Standard Practice for Conducting Black Box and Solar Concentrating Exposures of Coatings
N D4141/D4141M
Annotation
This practice covers two accelerated outdoor exposure procedures for evaluating the exterior weather resistance of coatings applied to substrates.
The two procedures are as follows:
Procedure A - Black Box Exposure.
Procedure C - Fresnel Reflector Rack Exposure.
NOTE 1 - Procedure B described a Heated Black Box procedure that is no longer in common use.
This standard does not cover all the procedures that are available to the user for accelerating the outdoor exposure of coatings. Other procedures have been used in order to provide a particular effect; however, the two procedures described here are widely used.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
