ASTM D3928 REV A Standard Test Method for Evaluation of Gloss or Sheen Uniformity
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D4940 Standard Test Method for Conductimetric Analysis of Water Soluble Ionic Contamination of Blasting Abrasives
- ASTM F941 Standard Practice for Inspection of Marine Surface Preparation and Coating Application
- 47
- ASTM F941 Standard Practice for Inspection of Marine Surface Preparation and Coating Application
- 47.020
- BSI BS ISO/IEC 15457-3 Identification cards - Thin flexible cards - Part 3: Test methods
- ISO 4677-1 Atmospheres for Conditioning and Testing - Determination of Relative Humidity - Part 1: Aspirated Psychrometer Method First Edition
- ISO 8502-4 Preparation of Steel Substrates Before Application of Paint and Related Products - Tests for the Assessment of Surface Cleanliness - Part 4: Guidance on the Estimation of the Probability of Condensation Prior to Paint Application - First Edition
- ISO 4677-1 Atmospheres for Conditioning and Testing - Determination of Relative Humidity - Part 1: Aspirated Psychrometer Method First Edition
- ISO 4677-1 Atmospheres for Conditioning and Testing - Determination of Relative Humidity - Part 1: Aspirated Psychrometer Method First Edition
- ISO 8502-4 Preparation of Steel Substrates Before Application of Paint and Related Products - Tests for the Assessment of Surface Cleanliness - Part 4: Guidance on the Estimation of the Probability of Condensation Prior to Paint Application - First Edition
- ISO 8502-4 Preparation of Steel Substrates Before Application of Paint and Related Products - Tests for the Assessment of Surface Cleanliness - Part 4: Guidance on the Estimation of the Probability of Condensation Prior to Paint Application - First Edition
- ASTM F718 Standard Specification for Shipbuilders and Marine Paints and Coatings Product/ Procedure Data Sheet
- ASTM D523 Standard Test Method for Specular Gloss
- ASTM D6763 Standard Guide for Testing Exterior Wood Stains and Clear Water Repellents
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Evaluation of Gloss or Sheen Uniformity
N D3928 REV A
Annotation
This test method covers the determination of the uniformity of gloss or sheen of a paint applied by brush to a test panel simulating an interior wall section. Variations in gloss or sheen that may be caused by short wet edge time, poor leveling, and pigment orientation or flotation during and after application are evaluated visually.
Because both the application and the panel evaluation are very subjective, this test method should be used only for comparative testing within one laboratory as the ratings assigned by different laboratories do not usually agree (see 8.1).
The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use
Автоматический перевод:
Метод стандартной пробы для оценки однородности блеска или блеска
Этот метод испытаний покрывает определение однородности блеска или блеска краски, примененной щеткой к испытательной группе, моделирующей внутреннюю стенную секцию. Изменения в блеске или блеске, который может быть вызван коротким влажным временем края, плохим выравниванием, и ориентацией пигмента или плаванием в течение и после применения, оценены визуально.
