JSA JIS K 6262 Rubber, vulcanized or thermoplastic - Determination of compression set at ambient, elevated or low temperatures
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.040.60
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- 23.100
- SNV SN EN ISO 19879 Metallic tube connections for fluid power and general use - Test methods for hydraulic fluid power connections
- ISO 6162-1 Hydraulic fluid power - Flange connections with split or one-piece flange clamps and metric or inch screws - Part 1: Flange connectors, ports and mounting surfaces for use at pressures of 3,5 MPa (35 bar) to 35 MPa (350 bar), DN 13 to DN 127 - Second Edition
- JSA JIS B 8363 End fittings and adapters for hydraulic hose assemblies
- JSA JIS B 2401-1 O-rings - Part 1: O-rings
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Rubber, vulcanized or thermoplastic - Determination of compression set at ambient, elevated or low temperatures
N JIS K 6262
Annotation
This Standard specifies methods for the determination of compression set of vulcanized and thermoplastic rubbers at ambient, elevated or low temperatures.
NOTE: The International Standards corresponding to this Standard and the symbol of degree of correspondence are as follows:
ISO 815-1 : 2008 Rubbe, vulcanized or thermoplastic - Determination of compression set - Part 1 : At ambient or elevated temperatures
ISO 815-2 : 2008 Rubbe, vulcanized or thermoplastic - Determination of compression set - Part 2 : At low temperatures (overall evaluation: MOD)
The symbols which denote the degree of correspondence in the contents between the relevant International Standards and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/lEC Guide 21-1.
Автоматический перевод:
Резина, вулканизировавшая или термопласт - Определение пластичной деформации при окружающих, поднятых или низких температурах
Этот Стандарт определяет методы для определения пластичной деформации вулканизировавших и термопластичных каучуков при окружающих, поднятых или низких температурах.
