ASTM International

Standard Test Method for Blocking Load of Plastic Film by the Parallel Plate Method
 N D3354

Annotation

This test method yields quantitative information regarding the degree of blocking (unwanted adhesion) existing between layers of plastic film. It is not intended to measure susceptibility to blocking.

By this procedure, the film-to-film adhesion, expressed as a blocking load in grams, will cause two layers of film with an area of contact of 100 cm2 to separate. The test method is limited to a maximum load of 200 g.

The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1—This test method is similar to ISO 11502 Method B, but is not technically equivalent.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Метод стандартной пробы для блокирования груза термопластической пленки параллельным чашечным методом

Этот метод тестирования приводит к количественным данным относительно степени блокирования (нежелательная адгезия) существующий между уровнями пластмассовой пленки. Это не предназначается для измерения чувствительности к блокированию.