Deutsches Institut fur Normung e. V.

Quality requirements in adhesive bonding technology
 N DVS 3310

Annotation

Introduction

This technical code describes the requirements on users who are either planning to use adhesive bonding technology or who are already using adhesive bonding technology. This technical code is not specific to a particular bonding task and can therefore be utilised for all adhesive bonding work.

The technical code is both a guide and an aid for users. It will allow them to make decisions on measures for an in-house quality assurance system for adhesive bonding. These measures will enable them to meet the requirements laid down in regulations or laid down by their customers in contracts.

In order to be able to successfully plan adhesive bonding work, the company management must make the following decisions in advance:

– Confirm that adhesive bonding is to be carried out

– Specify the highest class of bonded joint (see Section 5) that is to be manufactured at the company

– Define the scope of the adhesive bonding process (with regard to the value added at the company)

– Make decisions about what is undertaken in-house and what work is outsourced (e.g. design, purchasing, production, maintenance, etc.)

– Define the relevance of adhesive bonding technology for the company.

The scope of the resulting work must be estimated based on the requirements laid down in this technical code and must be compared with the potential benefits for the company. Adhesive bonding technology can only be successfully used if the company creates the necessary boundary conditions.