ASTM C408 Standard Test Method for Thermal Conductivity of Whiteware Ceramics
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D1039 Standard Test Methods for Glass-Bonded Mica Used as Electrical Insulation
- 29
- ASTM F144 Standard Practice for Making Reference Glass-Metal Sandwich Seal and Testing for Expansion Characteristics by Polarimetric Methods
- ASTM F105 Standard Specification for Type 58 Borosilicate Sealing Glass
- ASTM F140 Standard Practice for Making Reference Glass-Metal Butt Seals and Testing for Expansion Characteristics by Polarimetric Methods
- ASTM F105 Standard Specification for Type 58 Borosilicate Sealing Glass
- ASTM F105 Standard Specification for Type 58 Borosilicate Sealing Glass
- ASTM F140 Standard Practice for Making Reference Glass-Metal Butt Seals and Testing for Expansion Characteristics by Polarimetric Methods
- ASTM F140 Standard Practice for Making Reference Glass-Metal Butt Seals and Testing for Expansion Characteristics by Polarimetric Methods
- ASTM F79 Standard Specification for Type 101 Sealing Glass
- ASTM D116 Standard Test Methods for Vitrified Ceramic Materials for Electrical Applications
- ASTM D2149 Standard Test Method for Permittivity (Dielectric Constant) And Dissipation Factor Of Solid Dielectrics At Frequencies To 10 MHz And Temperatures To 500°C
- ASTM D2442 Standard Specification for Alumina Ceramics for Electrical and Electronic Applications
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Thermal Conductivity of Whiteware Ceramics
N C408
Annotation
This test method covers a general procedure2 for determining the thermal conductivity of whiteware ceramics over the temperature range from 100 to 300°F (40 to 150°C).
The values stated in inch-pound units are to be regarded as the standard. The SI (metric) units given in parentheses are for information purposes only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
2 This work was done under the sponsorship of the U.S. Signal Corps., Squier Signal Laboratory, Ft. Monmouth, NJ, and the U.S. Air Force, Wright-Patterson Air Development Center, OH.
Автоматический перевод:
Стандартный метод испытаний для теплопроводности керамики Whiteware
Этот метод тестирования покрывает общий procedure2 для определения теплопроводности whiteware керамики по диапазону температур от 100 до 300°F (40 к 150°C).
Значения, утвержденные в модулях дюйма-фунта, должны рассматриваться как стандарт. SI (метрика) модули, данные в круглых скобках, только в информационных целях.
