ASTM International

Standard Practice for Determining Surface Temperature of Molds for Plastics
 N D957

Annotation

This practice is intended for determining the temperature at a specified point or points on the surface of the cavity and base of a mold for plastics. By determining the temperature at as many points as deemed necessary, the overall temperature condition of the surface can be determined.

The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

NOTE 1-There is no known ISO equivalent to this standard.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Общепринятая практика для определения температуры поверхности форм для пластмасс

Эта практика предназначается для определения температуры в указанном пункте или пунктах на поверхности впадины и основе формы для пластмасс. Путем определения температуры в стольких же пунктов сколько считавший необходимым, может быть определено полное температурное условие поверхности.