CEN EN 847-2 Tools for woodworking - Safety requirements - Part 2: Requirements for the shank of shank mounted milling
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- 23
- CEN CEN/TR 13931 Rotodynamic pumps - Forces and moments on flanges - Centrifugal, mixed flow and axial flow horizontal and vertical shafts pumps - Incorporating Corrigendum June 2010
- 23.080
- ISO GUIDE 31 Reference Materials - Contents of Certificates and Labels - Second Edition
- CEN EN 16480 Pumps - Minimum required efficiency of rotodynamic water pumps
- 71
- ISO GUIDE 31 Reference Materials - Contents of Certificates and Labels - Second Edition
- CEN EN 16480 Pumps - Minimum required efficiency of rotodynamic water pumps
- 71.040
- ISO GUIDE 31 Reference Materials - Contents of Certificates and Labels - Second Edition
- CEN EN 16480 Pumps - Minimum required efficiency of rotodynamic water pumps
- ISO GUIDE 31 Reference Materials - Contents of Certificates and Labels - Second Edition
- ISO GUIDE 31 Reference Materials - Contents of Certificates and Labels - Second Edition
- CEN EN 16480 Pumps - Minimum required efficiency of rotodynamic water pumps
- CEN EN ISO 5198 Centrifugal, Mixed Flow and Axial Pumps - Code for Hydraulic Performance Tests - Precision Class
- BSI BS EN 13275 Cryogenic Vessels - Pumps for Cryogenic Service
- CEN EN ISO 9908 Technical specifications for centrifugal pumps - Class III - Incorporates Amendment A1: 2011
- ISO 1940-1 CORR 1 Mechanical vibration — Balance quality requirements for rotors in a constant (rigid) state — Part 1: Specification and verification of balance tolerances TECHNICAL CORRIGENDUM 1 - Second Edition
- Картотека зарубежных и международных стандартов
European Committee for Standardization
Tools for woodworking - Safety requirements - Part 2: Requirements for the shank of shank mounted milling
N EN 847-2
Annotation
This European Standard specifies the determination of the maximum speed for given eccentricity at clamping devices for the shank strength of milling tools with cylindrical and taper shank. It also specifies the marking of the tool. Bore mounted tools which are mounted on an arbour should be considered as a shank mounted tool.
This European Standard complements EN 847-1 and applies also for shank tools with a cutting diameter of less than 16 mm.
Автоматический перевод:
Инструменты для деревообработки - Требования техники безопасности - Часть 2: Требования для стержня стержня, смонтированного, дробя
Этот европейский стандарт определяет определение максимальной скорости для данного эксцентриситета в зажимных устройствах для силы стержня дробления инструментов со стержнем сужения и цилиндрическим. Это также определяет маркировку инструмента. Расточка смонтировала инструменты, монтирующиеся на беседке, должен быть рассмотрен, поскольку стержень смонтировал инструмент.
