ASTM D1384 Standard Test Method for Corrosion Test for Engine Coolants in Glassware
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- BSI BS 3396-1 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 1: Specification for Loom-State Fabrics
- 59
- BSI BS 3396-1 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 1: Specification for Loom-State Fabrics
- 59.100
- BSI BS 3396-1 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 1: Specification for Loom-State Fabrics
- 59.100.10
- BSI BS 3396-1 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 1: Specification for Loom-State Fabrics
- BSI BS 3396-2 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 2: Desized Fabrics
- BSI BS 3396-2 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 2: Desized Fabrics
- BSI BS 3396-3 Woven Glass Fibre Fabrics for Plastics Reinforcement Part 3: Finished Fabrics for Use with Polyester Resin Systems
- BSI BS PL 6 Properties of unsaturated polyester resins for low pressure laminating of glass fibre reinforced composites - Specification
- BSI BS 6580 Specification for corrosion inhibiting, engine coolant concentrate (“antifreeze”)
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Method for Corrosion Test for Engine Coolants in Glassware
N D1384
Annotation
This test method covers a simple beaker-type procedure for evaluating the effects of engine coolants on metal specimens under controlled laboratory conditions (see Appendix X1).
NOTE 1-For more information on engine coolants, see (Refs 1-8).2
The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in 10.1.7.2, 10.1.7.3, and 10.1.7.4.
2 The boldface numbers in parentheses refer to the list of references at the end of this standard.
Автоматический перевод:
Метод стандартной пробы для коррозионного испытания для хладагентов двигателя в стеклянной посуде
Этот метод испытаний покрывает простую процедуру типа мензурки для оценки эффектов хладагентов двигателя на металлических экземплярах при лабораторных условиях, которыми управляют (см. Приложение X1).
