CGSB CAN/CGSB-43.123-2010 Aerosol Containers and Gas Cartridges for Transport of Dangerous Goods
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- CGSB CAN/CGSB-43.123-2010 Aerosol Containers and Gas Cartridges for Transport of Dangerous Goods
- 55
- BSI BS 3424-34 Testing Coated Fabrics - Part 34: Method 37. Method for Determination of Water Vapour Permeability Index (WVPI)
- 59
- BSI BS 3424-34 Testing Coated Fabrics - Part 34: Method 37. Method for Determination of Water Vapour Permeability Index (WVPI)
- 59.080
- BSI BS 3424-34 Testing Coated Fabrics - Part 34: Method 37. Method for Determination of Water Vapour Permeability Index (WVPI)
- BSI BS 3546 Coated Fabrics for Use in the Manufacture of Water Penetration Resistant Clothing
- BSI BS 3424-24 Testing Coated Fabrics - Part 24: Methods 27A and 27B - Methods for Determination of Abrasion Resistance
- BSI BS 3900-0 Methods of test for paints - Part 0: Index of test methods
- BSI BS 3900-A8 Methods of Test for Paints Group A: Tests on Liquid Paints (Excluding Chemical Tests) Part A8: Methods of Test for Flash/No Flash (Closed Cup Equilibrium Method)
- BSI BS 5597 Specification for Non-Refillable Plastics Aerosol Dispensers up to 1000 mL Capacity
- Картотека зарубежных и международных стандартов
Canadian General Standards Board
Aerosol Containers and Gas Cartridges for Transport of Dangerous Goods
N CAN/CGSB-43.123-2010
Annotation
Organization and Content
This standard sets out the requirements for the design, manufacture, testing and inspection of non-refillable containers with a capacity of not more than 1 L and their selection and use for the handling, offering for transport and transport of UN1950, aerosols and UN2037, gas cartridges, in Canada. This standard also provides requirements for a quality management system and Transport Canada registration. This standard consists of six main sets of requirements.
Sections 1 through 3 specify general requirements, normative references and definitions.
Sections 4 and 5 specify the requirements for the design, construction, testing and marking of aerosol containers and gas cartridges for use in Canada.
Section 6 specifies the quality management system requirements for manufacturers of aerosol containers and gas cartridges.
Section 7 specifies the Transport Canada registration requirements for manufacturers of aerosol containers and gas cartridges.
Section 8 specifies the requirements for the selection and use of aerosol containers and gas cartridges in Canada.
Section 9 specifies the requirements for the transport of containers intended for disposal from a collection facility.
Application
The standard applies to aerosol containers and gas cartridges with a capacity equal to or less than 1 L and an inside diameter equal to or less than 76 mm.
