ASME B18.1.3M Metric Small Solid Rivets 12 mm Nominal Diameter and Smaller - Errata - October 1985
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13.040
- ASTM D7202 Standard Test Method for Determination of Beryllium in the Workplace by Extraction and Optical Fluorescence Detection
- 13.040.30
- ULC ULC-S564-06 STANDARD FOR CATEGORIES 1 AND 2 FOAM LIQUID CONCENTRATES - Second Edition
- ULC CAN/ULC-S560-06 STANDARD FOR CATEGORY 3 AQUEOUS FILM-FORMING FOAM (AFFF) LIQUID CONCENTRATES - Second Edition
- ASTM B995 REV A Standard Test Method for Chloride Resistance Test for Chromium Electroplated Parts (Russian Mud Test)
- ASTM B117 Standard Practice for Operating Salt Spray (Fog) Apparatus
- ASTM F2832 Standard Guide for Accelerated Corrosion Testing for Mechanical Fasteners
- ASME B18.12 Glossary of Terms for Mechanical Fasteners
- ASME B18.30.1M Open-End Blind Rivets with Break Mandrels (Metric Series)
- Картотека зарубежных и международных стандартов
ASME International
Metric Small Solid Rivets 12 mm Nominal Diameter and Smaller - Errata - October 1985
N B18.1.3M
Annotation
This Standard covers complete general and dimensional data for those types of metric small solid rivets recognized as American National Standard. Included is an appendix covering formulas on which dimensional data are based. It should be understood, however, that where questions arise concerning acceptance of a product, the dimensions in the tables shall govern over recalculation by formula.
The inclusion of dimensional data in this Standard is not intended to imply that all of the products described are stock production sizes. Consumers should consult with manufacturers concerning the availability of products. For recommended diameter-length combinations, refer to Table 7.
Metric small solid rivets purchased for Government use shall conform to this Standard and additionally to the requirements of Appendix II.
Автоматический перевод:
Метрический Маленький Номинальный диаметр 12 мм Цельных заклепок и Меньший - Опечатки - октябрь 1985
Этот Стандарт покрытия заканчивает общие и размерные данные для тех типов метрических маленьких цельных заклепок, признанных американским Национальным Стандартом. Включенный приложение, закрывающее формулы, на которых базируются размерные данные. Нужно подразумевать, однако, что, где вопросы возникают относительно принятия продукта, измерения в столах должны управлять по перерасчету формулой.
