ASTM D3554 Standard Specification for Track-Resistant Black Thermoplastic High-Density Polyethylene Insulation for Wire and Cable, 75 °C Operation
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- UL 444 UL Standard for Safety Communications Cables - Fourth Edition; Reprint with Revisions Through and Including April 30, 2015
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 29.220
- 33
- IEC 62680-2-3 Universal serial bus interfaces for data and power - Part 2-3: Universal Serial Bus Cables and Connectors Class Document Revision 2.0 - Edition 1.0
- 33.120
- 35
- ASTM D4565 Standard Test Methods for Physical and Environmental Performance Properties of Insulations and Jackets for Telecommunications Wire and Cable
- ASTM D2633 REV A Standard Test Methods for Thermoplastic Insulations and Jackets for Wire and Cable
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Track-Resistant Black Thermoplastic High-Density Polyethylene Insulation for Wire and Cable, 75 °C Operation
N D3554
Annotation
This specification covers track-resistant black thermoplastic high-density polyethylene insulation. Before application to the conductor, the insulation shall comply with the requirements of Specification D1248, Type III, Class C, Category 5, Grade E10, J4, or J5. The requirements of Specification D1248 shall not apply to the insulation removed from the conductor.
This type of insulation is considered suitable for use on wire or cable that will be used for continuous operation at conductor temperatures up to 75 °C.
This insulation is suitable for use on wire or in cable used for power transmission in overhead spaced-line service, installed at temperatures above 25 °C and exposed to sunlight and other atmospheric environments between 55 and +75 °C.
In many instances, the insulation cannot be tested unless it has been formed around a conductor. Therefore, tests done on insulated wire in this standard are solely to determine the relevant property of the insulation and not to test the conductor or completed cable.
Whenever two sets of values are presented, in different units, the values in the first set are the standard, while those in parentheses are for information only.
Автоматический перевод:
Стандартная спецификация для стойкой к следу черной термопластической высокоплотной изоляции полиэтилена для провода и кабеля, 75 °C операций
