IEC 61854 Overhead Lines - Requirements and Tests for Spacers - Edition 1.0
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- IEC TS 60479-1 CORR 1 Effects of current on human beings and livestock – Part 1: General aspects CORRIGENDUM 1 - Edition 4.0
- 13
- 29
- CSA CAN/CSA-C22.2 NO. 60529:05 Degres de protection procures par les enveloppes (Code IP) - First Edition
- IEC 60071-2 Insulation co-ordination - Part 2: Application guide - Edition 3.0
- CENELEC EN 62501 Voltage sourced converter (VSC) valves for high-voltage direct current (HVDC) power transmission - Electrical testing - Incorporates Amendment A1: 2014
- IEC 60071-2 Insulation co-ordination - Part 2: Application guide - Edition 3.0
- CENELEC EN 62501 Voltage sourced converter (VSC) valves for high-voltage direct current (HVDC) power transmission - Electrical testing - Incorporates Amendment A1: 2014
- IEC TR 60071-4 Insulation co-ordination Part 4: Computational guide to insulation co-ordination and modelling of electrical networks - Edition 1.0
- CENELEC EN 60433 Insulators for Overhead Lines with a Nominal Voltage Above 1 kv Ceramic Insulators for a.c. Systems Characteristics of Insulator Units of the Long Rod Type
- CENELEC EN 50341-1 Overhead electrical lines exceeding AC 1 kV - Part 1: General requirements - Common specifications
- Картотека зарубежных и международных стандартов
International Electrotechnical Commission
Overhead Lines - Requirements and Tests for Spacers - Edition 1.0
N 61854
Annotation
This International Standard applies to spacers for conductor bundles of overhead lines. It covers rigid spacers, flexible spacers and spacer dampers.
It does not apply to interphase spacers, hoop spacers and bonding spacers.
NOTE – This standard is written to cover the line design practices and spacers most commonly used at the time of writing. There may be other spacers available for which the specific tests reported in this standard may not be applicable.
In many cases, test procedures and test values are left to agreement between purchaser and supplier and are stated in the procurement contract. The purchaser is best able to evaluate the intended service conditions, which should be the basis for establishing the test severity.
In annex A, the minimum technical details to be agreed between purchaser and supplier are listed.
Автоматический перевод:
Верхние линии - требования и испытания на распорные детали - издание 1.0
Уважаемый пользователь!
Обратитесь к обслуживающему Вас представителю за дополнительной информацией о возможности приобретения документов указанного разработчика и заказа перевода.



