ASTM F606/F606M REV A Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F3043 Standard Specification for “Twist Off” Type Tension Control Structural Bolt/Nut/Washer Assemblies, Alloy Steel, Heat Treated, 200 ksi Minimum Tensile Strength
- ASTM F2660 Standard Test Method for Qualifying Coatings for Use on A490 Structural Bolts Relative to Environmental Hydrogen Embrittlement
- 21
- ASTM F2660 Standard Test Method for Qualifying Coatings for Use on A490 Structural Bolts Relative to Environmental Hydrogen Embrittlement
- 21.060
- ASTM E2624 Standard Practice for Torque Calibration of Testing Machines and Devices
- ASTM E2207 Standard Practice for Strain-Controlled Axial-Torsional Fatigue Testing with Thin - Walled Tubular Specimens
- ASTM E1417/E1417M Standard Practice for Liquid Penetrant Testing
- ASTM E2207 Standard Practice for Strain-Controlled Axial-Torsional Fatigue Testing with Thin - Walled Tubular Specimens
- ASTM E2207 Standard Practice for Strain-Controlled Axial-Torsional Fatigue Testing with Thin - Walled Tubular Specimens
- ASTM E1417/E1417M Standard Practice for Liquid Penetrant Testing
- ASTM E1417/E1417M Standard Practice for Liquid Penetrant Testing
- ASTM F519 Standard Test Method for Mechanical Hydrogen Embrittlement Evaluation of Plating/ Coating Processes and Service Environments
- ASTM F606/F606M REV A Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
- ASTM A183 Standard Specification for Carbon Steel Track Bolts and Nuts
- Картотека зарубежных и международных стандартов
ASTM International
Standard Test Methods for Determining the Mechanical Properties of Externally and Internally Threaded Fasteners, Washers, Direct Tension Indicators, and Rivets
N F606/F606M REV A
Annotation
These test methods cover establishment of procedures for conducting tests to determine the mechanical properties of externally and internally threaded fasteners, washers, direct tension indicators, and rivets.
Property requirements and the applicable tests for their determination are specified in individual product standards. In those instances where the testing requirements are unique or at variance with these standard procedures, the product standard shall specify the controlling testing requirements. In the absence of any specified test requirement(s), these test methods shall apply.
The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
NOTE 1—The values are stated in inch-pound for inch fasteners and SI metric units for metric fasteners.
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
*A Summary of Changes section appears at the end of this standard
Автоматический перевод:
