ASTM International

Standard Specification for Socket-Type Polyethylene Fittings for Outside Diameter-Controlled Polyethylene Pipe and Tubing
 N D2683

Annotation

This specification covers polyethylene socket-type fittings for use with outside diameter-controlled polyethylene pipe as specified by Specifications D3035 and D2513. Requirements for materials, workmanship, dimensions, and pressure performance are included. Where applicable in this specification, " pipe" shall mean "pipe and tubing."

The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Стандартная спецификация для деталей полиэтилена типа гнезда для управляемой наружным диаметром полиэтиленовой трубы и трубки

Эта спецификация покрывает детали типа гнезда полиэтилена для использования с управляемой наружным диаметром полиэтиленовой трубой, как определено Спецификациями D3035 и D2513. Требования для материалов, мастерства, измерений и производительности давления включены. Где применимо в этой спецификации, "труба" должна означать "трубу и трубку".