JSA JIS C 60068-2-30 Environmental testing - Part 2-30: Tests-Test Db: Damp heat, cyclic (12 h + 12 h cycle)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- JSA JIS C 60068-3-7 Environmental testing - Part 3-7: Supporting documentation and guidance - Measurements in temperature chambers for tests A and B (with load)
- 19
- JSA JIS C 60068-3-7 Environmental testing - Part 3-7: Supporting documentation and guidance - Measurements in temperature chambers for tests A and B (with load)
- 19.040
- JSA JIS C 60068-3-7 Environmental testing - Part 3-7: Supporting documentation and guidance - Measurements in temperature chambers for tests A and B (with load)
- JSA JIS C 60068-3-5 Environmental testing - Part 3-5: Supporting documentation and guidance - Confirmation of the performance of temperature chambers
- 29
- JSA JIS C 60068-3-7 Environmental testing - Part 3-7: Supporting documentation and guidance - Measurements in temperature chambers for tests A and B (with load)
- 29.020
- JSA JIS C 60068-3-7 Environmental testing - Part 3-7: Supporting documentation and guidance - Measurements in temperature chambers for tests A and B (with load)
- JSA JIS C 60068-3-5 Environmental testing - Part 3-5: Supporting documentation and guidance - Confirmation of the performance of temperature chambers
- JSA JIS C 60068-1 Environmental testing Part 1: General and guidance
- JSA JIS C 60068-2-30 Environmental testing - Part 2-30: Tests-Test Db: Damp heat, cyclic (12 h + 12 h cycle)
- JSA JIS C 60068-3-4 Environmental testing - Part 3-4: Supporting documentation and guidance - Damp heat tests
- Картотека зарубежных и международных стандартов
Japanese Standards Association
Environmental testing - Part 2-30: Tests-Test Db: Damp heat, cyclic (12 h + 12 h cycle)
N JIS C 60068-2-30
Annotation
This Standard determines the suitability of components, equipment or other articles for use, transportation and storage under conditions of high humidity-combined with cyclic temperature changes and, in general, producing condensation on the surface of the specimen.
For small, low mass specimens, it may be difficult to produce condensation on the surface of the specimen using this procedure; users should consider the use of an alternative procedure such as that given to JIS C 60068-2-38.
NOTE: The International Standard corresponding to this Standard and the symbol of degree of correspondence are as follows.
IEC 60068-2-30: 2005 Environmental testing-Part 2-30: Tests-Test Db: Damp heat, cyclic (12 h + 12 h cycle) (IDT)
In addition, symbols which denote the degree of correspondence in the contents between the relevant International Standard and JIS are IDT (identical), MOD (modified), and NEQ (not equivalent) according to ISO/IEC Guide 21-1.
Автоматический перевод:
Экологическое тестирование - Часть 2-30: испытательный тест Db: Влажное тепло, цикличное (12 ч + цикл 12 ч)
Этот Стандарт определяет пригодность компонентов, оборудования или других предметов для использования, транспортировки и хранения при условиях высоких, объединенных с влажностью с циклическими изменениями температуры и, в целом, производя уплотнение на поверхности экземпляра.
