ASTM D2852 Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ASTM F449 Standard Practice for Subsurface Installation of Corrugated Polyethylene Pipe for Agricultural Drainage or Water Table Control
- 23
- ASTM F2390 Standard Specification for Poly(Vinyl Chloride) (PVC) Plastic Drain, Waste, and Vent (DWV) Pipe and Fittings Having Post-Industrial Recycle Content
- ASTM F412 Standard Terminology Relating to Plastic Piping Systems
- ASTM F480 Standard Specification for Thermoplastic Well Casing Pipe and Couplings Made in Standard Dimension Ratios (SDR), SCH 40 and SCH 80
- ASTM F412 Standard Terminology Relating to Plastic Piping Systems
- ASTM F480 Standard Specification for Thermoplastic Well Casing Pipe and Couplings Made in Standard Dimension Ratios (SDR), SCH 40 and SCH 80
- ASTM D2122 Standard Test Method for Determining Dimensions of Thermoplastic Pipe and Fittings
- ASTM F810 Standard Specification for Smoothwall Polyethylene (PE) Pipe for Use in Drainage and Waste Disposal Absorption Fields
- ASTM D2852 Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
- ASTM F481 Standard Practice for Installation of Thermoplastic Pipe and Corrugated Pipe in Septic Tank Leach Fields
- Картотека зарубежных и международных стандартов
ASTM International
Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
N D2852
Annotation
This specification covers requirements and test methods for materials, dimensions, workmanship, impact resistance, load-deflection properties, dimensional stability, and joint tightness of plain-end or bell-end styrene-rubber (SR) plastic drain pipe and fittings in sizes 2 through 6 in.
The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Автоматический перевод:
Стандартная спецификация для канала дренажа пластмассы Резины стирола (SR) и деталей
Эта спецификация удовлетворяет требования и методы тестирования для материалов, размерностей, мастерства, ударопрочности, свойств отклонения загрузки, стабильности размеров и объединенной плотности простого конца или канала дренажа пластмассы резины стирола (SR) придурка и деталей в размерах 2 - 6 дюймов.
