ISO 199 Rolling bearings - Thrust bearings - Geometrical product specification (GPS) and tolerance values - Fourth Edition
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- 21
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- 21.100
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- 21.100.20
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- CEN EN ISO 10318 Geosynthetics - Terms and definitions
- CEN EN 13492 Geosynthetic barriers - Characteristics required for use in the construction of liquid waste disposal sites, transfer stations or secondary containment
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- CEN EN 13492 Geosynthetic barriers - Characteristics required for use in the construction of liquid waste disposal sites, transfer stations or secondary containment
- CEN EN 13492 Geosynthetic barriers - Characteristics required for use in the construction of liquid waste disposal sites, transfer stations or secondary containment
- ISO 113 Rolling bearings — Plummer block housings — Boundary dimensions - Third Edition
- DIN 738 Rolling bearings - Plummer block housings for rolling bearings of diameter series 2 with cylindrical bore
- DIN 625-1 Rolling bearings - Radial deep groove ball bearings - Part 1: Single row
- DIN 625-4 Rolling bearings - Radial deep groove ball bearings - Part 4: With flanged outer ring
- DIN 625-3 Rolling bearings - Radial deep groove ball bearings - Part 3: Double row
- DIN 620-6 Rolling bearings - Rolling bearing tolerances - Part 6: Chamfer dimension limits
- DIN 711 Rolling bearings - Single direction thrust ball bearings
- Картотека зарубежных и международных стандартов
International Organization for Standardization
Rolling bearings - Thrust bearings - Geometrical product specification (GPS) and tolerance values - Fourth Edition
N 199
Annotation
This International Standard specifies dimensional characteristics, limit deviations from nominal values, and tolerance values to define the interface (except chamfers) of thrust rolling bearings. Nominal boundary dimensions are defined in ISO 104[1].
This International Standard is not applicable to certain thrust bearings (e.g. thrust needle roller bearings) or for particular fields of application (e.g. special thrust precision bearings). Tolerances for such bearings are given in the relevant International Standards.
Chamfer dimension limits are given in ISO 582[3].
Автоматический перевод:
Роликовые подшипники - Упорные подшипники - Геометрическая техническая характеристика изделия (GPS) и значения допуска - Четвертый Выпуск
Этот Международный стандарт определяет размерные характеристики, предельные отклонения от номинальной стоимости и значения допуска для определения интерфейса (кроме закруглений кромок) роликовых подшипников тяги. Номинальные граничные измерения определены в ISO 104[1].
