ASTM International

Standard Practice for Evaluating the Quality of Molded Poly(Vinyl Chloride) (PVC) Plastic Pipe Fittings by the Heat Reversion Technique
 N F610/F610M

Annotation

This practice covers a procedure for evaluating the quality of molded poly(vinyl chloride) (PVC) plastic pipe fittings after exposure to heat.

Units-The values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

NOTE 1-The values in square brackets are SI units requirements.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

*A Summary of Changes section appears at the end of this standard

Автоматический перевод:

Общепринятая практика для оценки качества прессованных полей (винилхлорид) (PVC) детали пластмассовой трубы методом возвращения тепла

Эта практика покрывает процедуру для оценки качества прессованных полей (винилхлорид) (PVC) детали пластмассовой трубы после воздействия тепла.