DIN ISO 12240-4 Spherical plain bearing - Part 4: Spherical plain bearing rod ends (ISO 12240-4:1998)
Данный раздел/документ содержится в продуктах:
- Техэксперт: Машиностроительный комплекс
- Картотека зарубежных и международных стандартов
- DIN ISO 12240-4 Spherical plain bearing - Part 4: Spherical plain bearing rod ends (ISO 12240-4:1998)
- 21
- DIN ISO 12240-4 Spherical plain bearing - Part 4: Spherical plain bearing rod ends (ISO 12240-4:1998)
- 21.080
- ISO 582 Rolling Bearings - Chamfer Dimensions - Maximum Values - Third Edition
- 21.100
- ISO 582 Rolling Bearings - Chamfer Dimensions - Maximum Values - Third Edition
- BSI BS ISO 12240-4 Spherical Plain Bearings - Part 4: Spherical Plain Bearings Rod Ends - AMD 10760: November 1999
- ISO 12240-1 Spherical Plain Bearings - Part 1: Radial Spherical Plain Bearings - First Edition; This First Edition Cancels and Replaces ISO 6124-1:1987, ISO 6124-2:1982, ISO 6124-3:1982 and ISO 6125:1982
- Картотека зарубежных и международных стандартов
Deutsches Institut fur Normung e. V.
Spherical plain bearing - Part 4: Spherical plain bearing rod ends (:1998)
N ISO 12240-4
Annotation
This part of IS0 12240 specifies dimensions, tolerances and radial internal clearances for various dimension series of spherical plain bearing rod ends.
The dimensions and tolerances specified in this part of IS0 12240 have been selected to permit the design and use of spherical plain bearing rod ends which incorporate radial spherical plain bearings having various sliding material combinations.
The specified tolerance values apply for finished spherical plain bearing rod ends before any coating, plating, ring splitting or fracturing.
Spherical plain bearing rod ends need not conform to the designs illustrated but compliance is required as regards dimensions, tolerances and radial internal clearances specified.
NOTE - Spherical plain bearing rod ends for airframe applications and specific spherical plain baring rod ends for direct connection to hydraulic cylinders are not covered by this part of IS0 12240.
Автоматический перевод:
Лагерь сочленения - часть 4: Головы сочленения (ИЗО 12240-4:1998)
Эта часть IS0 12240 определяет измерения, допуски и радиальные внутренние документы для различной серии измерения сферических концов стержня простого подшипника.
